Publicité
PROBLEMS WITH THE ROLL WINDING
PROBLEM
The roll winder will not wind
inflated material.
The roll is a different
diameter than expected.
If the problem persists or the troubleshooting section does not resolve or
describe your problem, contact Uline Customer Service at 1-800-295-5510.
PAGE 4 OF 12
TROUBLESHOOTING CONTINUED
CAUSES
The winder is stopped.
The winder is not plugged in.
Obstruction blocking the winder or
the roll.
Electrical or mechanical failure.
The diameter setting is set
incorrectly.
Material roll is empty.
Electrical or mechanical failure.
π
1-800-295-5510
uline.com
RECOMMENDATIONS
Press the winder start button – see
Producing Air-Filled Material in Roll Winder
Mode on page 6 of the instructions.
Verify that the roll winder is plugged in to
the bottom of the machine.
Verify the roll can wind free of obstruction.
Contact Uline Customer Service.
Verify diameter setting – see Producing
Air-Filled Material in Roll Winder Mode on
page 6 of the instructions.
Load a new roll as required – see Loading
Material Roll on page 4 of the instructions.
Contact Uline Customer Service.
0325 TH-7259
Publicité
