PROBLEMS WITH MAKING INFLATED MATERIAL
PROBLEM
The material will not advance –
the control panel is on.
The material advances and
edge seals are present, but
the material does not fill
with air.
The material advances and
fills with air, but the material
does not seal properly.
PAGE 2 OF 12
TROUBLESHOOTING CONTINUED
CAUSES
Material roll is empty.
Material roll is improperly loaded.
Electrical or mechanical failure.
Material roll improperly loaded.
The material layers are not properly
wrapped around the inflation nozzle.
Faulty material.
Electrical or mechanical failure.
Material roll improperly loaded.
Faulty edge seal.
Faulty material.
Seal power out of adjustment.
Electrical or mechanical failure.
RECOMMENDATIONS
Load a new roll as required – See Loading
Material Roll on page 4 of the instructions.
Reload roll as required – See Loading
Material Roll on page 4 of the instructions.
Contact Uline Customer Service.
Verify that the open end of the material is
facing in towards the inflation nozzle.
Load new material – See Loading Material
Roll on page 4 of the instructions.
Return material roll – contact Uline
Customer Service.
Contact Uline Customer Service.
Reload material roll – see Loading the
Material Load on page 4 of the instructions.
Check condition of edge seal on the material.
Check condition of edge seal and verify that
it is fully seated.
Replace as required – see Replacing the
Edge Seal on page 7 of the instructions.
Load new material – see Loading the Material
Roll on page 4 of the instructions.
Return material roll – contact Uline Customer
Service.
Remove, re-install and calibrate the edge
seal – see Replacing the Edge Seal on page 7
of the instructions.
Contact Uline Customer Service.
0325 TH-7259