Uline BUBBLE FLEX H-7259 Mode D'emploi

H-7259
NEWAIR INSTANT
BUBBLE FLEX™ MACHINE
NO POWER TO THE SYSTEM
PROBLEM
There is no power to the
system and the control
panel display is OFF.
DISPLAYED FAULT MESSAGES
DISPLAYED MESSAGE
#01 E-Stop Pressed
#03 Clamp Open
#17 Check Film Path
#07 Edge Seal Fault
PAGE 1 OF 12
1-800-295-5510
uline.com
TROUBLESHOOTING
CAUSES
System is off.
Main power cord is unplugged at
the outlet.
Facility power supply is interrupted.
Electrical component failure.
CAUSES
E-Stop switch pressed.
Edge seal clamp is open.
Out of film.
Material roll is improperly loaded.
Edge seal wheel is missing or not
fully seated.
Edge seal failure.
Para Español, vea páginas 5-8.
Pour le français, consulter les pages 9-12.
RECOMMENDATIONS
Turn the main power switch to the on
position.
Verify the main power cord is plugged
into a properly rated outlet – see Electrical
Power Requirements on page 2 of the
instructions.
Verify facility power supply – see Electrical
Power Requirements on page 2 of the
instructions.
Contact Uline Customer Service at
1-800-295-5510.
RECOMMENDATIONS
Twist E-Stop to release.
Hinge the clamp handle up to close the
edge seal and press reset key.
Load new roll.
Reload roll as required.
Check condition of edge seal and verify
that it is fully seated.
Replace as required – see Replacing the
Edge Seal on page 7 of the instructions.
Contact Uline Customer Service.
0325 TH-7259