Publicité
PROBLEMS WITH MAKING INFLATED MATERIAL CONTINUED
PROBLEM
The inflated material leaks air.
The inflated material has an
inconsistent air-fill amount.
PAGE 3 OF 12
TROUBLESHOOTING CONTINUED
CAUSES
Material roll improperly loaded.
Faulty edge seal.
The operator is pulling the inflated
material directly out of the system
before the inflated material can cool.
Faulty material.
Seal power out of adjustment.
Electrical or mechanical failure.
Material roll improperly loaded.
Faulty material.
Ambient temperature needs to be
reset.
Electrical or mechanical failure.
Material has been affected by
storage conditions.
RECOMMENDATIONS
Reload material – see Loading the Material
Roll on page 4 of the instructions.
Check condition of edge seal on the material.
Check condition of edge seal and verify that
it is fully seated.
Replace as required – see Replacing the
Edge Seal on page 7 of the instructions.
Do not attempt to pull inflated material from
machine.
Load new material – see Loading the Material
Roll on page 4 of the instructions.
Return material roll – contact Uline Customer
Service.
Remove, re-install and calibrate the edge
seal – see Replacing the Edge Seal on page
7 of the instructions.
Contact Uline Customer Service.
Reload material roll – see Loading Material
Roll on page 4 of the instructions.
Load new material roll – see Loading Material
Roll on page 4 of the instructions.
Return material roll – contact Uline Customer
Service.
Unscrew top edge seal assembly and
reattach to recalibrate the temperature.
Contact Uline Customer Service.
Refer to storage conditions under Safety in
the instructions.
0325 TH-7259
Publicité
