Kamikaze KV 3 Manuel D'utilisation page 76

ELECTRONIC TYING MACHINE
• Wire track cleaning operation shall be performed according following
procedure:
1. Switch off power, disconnect the battery, pull up front cover snap buckle
with hand.
2. Pull out front cover in the direction shown in the figure.
3. Pull pressing plate open as shown in the figure.
4. Use a brush to clean up foreign matters in track as shown in the figure.
5. Use a bush to clear up foreign matters in front end binding wire area as
shown in the figure.
6. After completion of cleaning, fill sufficient lubricating oil (normal white
oil or machine oil) at cutter and each movable joint as shown in the figure.
76
www.kamikazevolpi.com