Kamikaze KV 3 Manuel D'utilisation page 63

ELECTRONIC TYING MACHINE
tying work exceeding the range of 25mm maximum diameter. The excess
of this range would damage the tying machine.
• Do not try to remove the stuck feeding hook or tying wire before turning
off the power.
• Tying work must be finished when feeding hook and wire-outgoing track
can stretch out and retract smoothly and there is no interference of other
foreign matters. Before staring the work of tying, please check objects
hidden in grave vines or branches, for example, electric wire, iron wire,
surplus branches and leaves, these things may affect the stretching out
and retracting of the feeding hook.
• When operating the tool, always hold it with one hand, and keep a
distance of at least 5cm away from the other hand and your whole body.
• Feeding system must be checked and cleaned frequently. If foreign
matters are accumulated in the feeding track, it will affect tying effect
and increase load to the equipment. Quality assurance does not include
the damage caused by the wrong maintenance mentioned above.
• Do not attempt to repair the tool yourself. Repair operations not
mentioned in this manual can only be performed by the personnel of our
service center.
• Use only the wire suggested by the producers. The usage of other wire
will invalid the warranty of the tool.
4.3 SPECIAL SAFETY INSTRUCTION FOR BATTERY TOOL
• Make sure the battery switch is in "OFF" position before insert battery.
The equipment can be damaged if inserting the battery at switch on.
63
www.kamikazevolpi.com