Troubleshooting - Haussmann Xpert 5848006 Manuel De L'utilisateur

SYMPTOM
Snipe
(gouging at ends of board)
Fuzzy grain
Torn grain
Rough raised grain
Uneven depth of cut
(side to side)
Rollercase elevation adjusts
with difficulty
Board feeds inside, but stops
moving past the outfeed roller
Board thickness does not
match depth of cut scale
Chain jumping
Planer will not operate
Belt slipping

TROUBLESHOOTING

POSSIBLE CAUSE(S)
1. Dull blades
2. Inadequate support of long boards
3. Uneven force on cutterhead
4. Rollercase not level with base
5. Lumber not butted property
Planing wood with a high moisture
content
1. Tool heavy a cut
2. Blades cutting against grain
3. Dull blades
1. Dull blades
2. Too heavy a cut
3. Moisture content too high
Rollercase not level with planer
base
1. Sprockets or chain dirty
2. Elevation screws, columns dirty
3. Elevation screws worn
4. Friction between rollercase and
covers
5. Rollercase not parallel with planer
base
6. Rollercase lock engaged
1. Outfeed rollers cannot rotate due
to clogging of chips
2. Too much pressure on the
cutterhead from long workpiece
Indicator not set correctly
1. Sprockets worn
2. Chain worn
1. No power to planer
2. Motor overload protection tripped
3. Defective or loose switch or wiring
Loose belt
CORRECTIVE ACTION
1. Replace blades per instructions.
See "Maintenance"
2. Support long boards. See "Avoiding Snipe"
3. Gently push board when board is in contact
with only one feed roller. See "Avoiding Snipe"
4. Adjust rollercase
See "Adjusting Table Level"
5. Butt end to end each piece of stock as
boards pass through planer
Remove high moisture content from wood by
drying
1. Review "Depth of Cut"
2. Review "Feeding Work"
3. Replace blades per instructions
See "Maintenance"
1. Replace blades per instructions.
See "Maintenance"
2. Review "Depth of Cut"
3. Dry the wood or use dried wood
Rollercase not level
See "Adjusting Table Level"
1. Clean and lubricate sprockets and chain
2. Clean and lubricate elevation screws, columns
3. Replace elevation screws
4. Clean and lubricate
5. Adjust rollercase
6. Release rollercase lock
1. Clear the clogging, clean dust collector
system. See "Clean Planer"
2. Use support stands to support workpiece
longer than 24".
Adjust indicator and tighten securely
1. Replace sprockets
2. Replace chain
1. Check power source by qualified electrician
2. Turn planer off. Reset motor overload
protection. See "Overload Reset"
3. Check switch and wiring by qualified
electrician
Replace belt, see "Replacing V-Belt"
30