Maintenance - Haussmann Xpert 5848006 Manuel De L'utilisateur

Planer will operate best if kept in good condition and
properly adjusted.
CHECK FOR WORN BLADES
• Condition of blades will affect precision of cut. Observe
quality of cut which planer produces to check condition
of blades.
• Dull blades will tear, rather than sever wood fibers and
produce fuzzy appearance.
• Raised grain will occur when dull blades pound on wood
that has varying density. Raised edge will also be
produced where blades have been nicked.
REPLACE BLADES
Refer to Figures 16, 17 and 18.
WARNING
Always turn planer OFF and disconnect from power
source before starting any maintenance work.
• Loosen and remove socket head bolts (A) from blade
cover (B) on the rear side of planer. Remove blade
cover.
• Carefully turn cutterhead by hand towards you until it is
stopped by the self-engaging latch.
• Loosen and remove six bolts from gib (C).
Figure 16 - Remove Blade Cover
Figure 17 - Remove Gib Bolts

MAINTENANCE

• Remove gib using two magnets (Figure 18) provided.
NOTE: Magnets can be easily disengaged from gib by
tilting them to left or right.
CAUTION: Blade edges are extremely sharp. Keep fingers
away from blades at all times.
• Blade is held on position by two pins. Gently lift old
blades from the pins using the two magnets. Do not
make contact with the blade using fingers. Use magnets
only.
Figure 18 - Remove Blade
• Replace with new blade and carefully position it on the
two pins using the two magnets.
• Replace gib and align the holes on the gib with holes on
the blade using the two magnets.
• Secure gib to cutterhead using six bolts removed earlier.
• Depress latch to release cutterhead. Release latch
when cutterhead can be turned by hand.
• Turn cutterhead by hand until it is stopped by
selfengaging latch.
• Remove gib and blade as mentioned earlier.
• Replace with new blade and replace gib and secure it
as mentioned earlier.
• Replace blade cover and secure it using socket head
bolts.
BRUSH INSPECTION AND REPLACEMENT
WARNING
Turn planer off and disconnect from power source. Brush
life depends on amount of load on motor. Regularly inspect
brushes after 100 hours of use. Brushes are located on
either side of planer motor.
28