Putting The Pool Cleaner Into The Pool - Maytronics Classic 4-UNI Mode D'emploi

5.2. Putting the Pool Cleaner into the pool

If your Pool Cleaner is equipped with brushes
that contain sponges, dip the brushes in the
water and squeeze them so that they will
absorb water the first time you use the
Pool Cleaner, or if the brushes have dried
out between uses.
Holding the Pool Cleaner upside down in
the water, gently rock it back and forth with
your fingers holding the plastic doors on
the bottom lid open to release trapped air.
Continue until no more bubbles are released.
Release the Pool Cleaner and let it sink to the
floor of the pool.
Make sure that the floating cable is free of any
obstructions.
To avoid kinks in the floating cable, place
approximately enough cable in the water for
the Pool Cleaner to reach the farthest corner of
the pool.
ON
Robotic Pool Cleaner Classic 4 / Top 4 - UNI
Turn the power supply ON.
The Pool Cleaner will now operate until it has
reached the end of the cleaning cycle.
User Instructions
|
5