Shutdown Instructions; Test Firing Heater; Storage; Maintenance Instructions - Reddyheater Rfg60Dc Mode D'emploi

WARNING:
Motor and fan must be
running before lighting, during operation
and at shutdown, in order to prevent a
flame-out condition which could result in
peronsal injury or poperty damage.
1. Turn gas valve knob clockwise
the minus sign "—" position.
2. Turn gas supply OFF by turning propane
tank valve clockwise
Test fire your construction heater, follow-
ing the lighting instructions applicable to the
gas control system employed. Leak test all
Never store a Propane gas tank inside a build-
ing or in the vicinity of any gas or oil burning
appliance. When the Propane tank is not dis-
connected from the construction heater, the
gas tank and heater must be stored outdoors
in a well ventilated area, out of the reach of
children. If for any reason the heater is to be
stored indoors, the tank must be disconnected
and stored outdoors in a well ventilated area

MAINTENANCE INSTRUCTIONS

1. Turn unit off, allow heater to fully cool
and disconnect propane hose before
performing any maintenance functions.
Remove the battery of unplug the
unit from the 120 volt receptacle.
WARNING:
Use only original
replacement parts. This Heater must use
design-specific parts. Do not substitute or
use generic parts. Improper replacement
parts could cause serious or fatal injuries.
This will also protect your warranty cover-
age for parts replaced under warranty.
FOR TECHNICAL ASSISTANCE SEE YOUR LOCAL RETAILER OR CONTACT
US AT:
PHONE: 800-776-9425
EMAIL: support@worldmkting.com or
info@worldmkting.com www.worldmkting.com
Page 11

SHUTDOWN INSTRUCTIONS

to close.

TEST FIRING HEATER

STORAGE

REPLACEMENT PARTS

3. Keep the heater running for 30 seconds
to get the excess heat out before turning
it OFF.
4. Toggle the ON/OFF switch to the OFF
" " position to turn off the fan motor
5. Disconnect the power cord once
to
the heater has cooled to ambient
temperature.
gas connections with soap solution. Soap
bubbles indicate gas leakage. DO NOT
use a match or flame to test for gas leaks.
out of reach of children, in accordance with the
standard for the the Storage and Handling of
Liquefied Petroleum Gases, ANSI / NFPA 58
and CSA B149.1, Natural Gas and Propane
Installation Code. The plastic tank valve plug
supplied with your tank must be tightly installed
when the tank is disconnected from the heater.
2. Keep unit clean and keep the inside
of the
3. Have unit checked by a qualified
technician
preferably prior to the heating season.
When calling, have ready:
• your name
• your address
• how heater was malfunctioning
• serial number of heater
• model number of heater
• replacement part number
tube housing debris
at least once
free.
a year,