Propane Safety; Leak Checking; Lighting Instructions - Reddyheater Rfg60Dc Mode D'emploi

Propane is safe to use when properly handled.
Careless handling of the Propane gas tank could
result in fire and/or an explosion. Therefore:
• Always keep tank/cylinder securely fastened
in an upright position.
• Avoid tipping tank on its side when
connected to a regulator since this may
cause damage to diaphragm in regulator.
• Handle valves with care.
• Never connect an unregulated Propane tank
to construction heater.
• Do not subject Propane tank to excessive
heat.
• Tightly close the
Check all gas connections with a soap solu-
tion to be sure they are tight and leak proof.
• The installation of your heater must meet
all local codes and/or gas utility require-
WARNING:
Motor and fan must be
running before lighting, during operation
and shutdown, in order to prevent a
flame-out condition which could result in
personal injury or property damange.
1. Connect power cord to a properly
grounded three (3) prong 120V, 60Hz,
single phase receptacle or insert DC bat-
tery as previously instructed.
2. Turn gas valve knob clockwise
minus sign "—" position.
3. Wait five (5) minutes to clear any gas.
Then smell for gas. If you don't smell
gas, go to next step
4. Turn gas supply ON by turning propane
tank valve counterclockwise

PROPANE SAFETY

gas shutoff valve

LEAK CHECKING

LIGHTING INSTRUCTIONS

to the
.
on the Propane tank after each use.
• The POL fitting must be protected when
disconnected from
• Never store a Propane gas tank inside a
building or in the vicinity of any gas burning
appliance.
THE DISCONNECTED TANK MUST NEVER
BE STORED IN A BUILDING, GARAGE
OR ANY OTHER ENCLOSED AREA.
ments or, in the absence of local codes, with
the Storage and Handling of Liquefied Petro-
leum Gases, ANSI/ NFPA 58 and the Natural
and Propane Installation Code, CSA B149.1.
5. Toggle the ON/OFF switch to the ON " |
" position. Keep the gas control knob at
the minus
sign "—" position.
6. Fully depress the ignition button " " and
hold until the electric spark lights the
burner.
7. Keep the ignition button " " pressed for
at least 30 seconds after the burner is lit.
After 30
seconds, release the ignition button.
8. If burner does not stay lit, repeat the
lighting procedure.
9. When burner is lit, turn gas valve knob
counterclockwise
the propane tank.
to desired setting.
Page 10