Battery Installation And Removal Instructions; Extension Cord Attachment; Heater Tilt Adjustment Instructions - Reddyheater Rfg60Dc Mode D'emploi

BATTERY INSTALLATION AND REMOVAL INSTRUCTIONS

To install the battery align it with the guide rails
on the Heater and push firmly until it clicks
into position. To remove the Battery, depress
the release Button and pull firmly outward.

EXTENSION CORD ATTACHMENT

To operate the Heater with 120V AC power
attach the female end of a 16 gauge, out-
door rated, three prong extension cord to
the socket located at the rear of the Heat-
er. Make sure the cord is fully inserted.

HEATER TILT ADJUSTMENT INSTRUCTIONS

The Heater has two tilt angles, LOW and
HIGH as illustrated in Figure 3 and 3a. To
move the Heater to either of these positions
the TILT Buttons must be depressed simulta-
neously while the front leg is pulled/ pushed
into position. A clicking sound indicates
the front leg has been properly positioned.
FIG. 2
Page 9
FIG. 3
FIG. 3A