Publicité
A heater has hot and arcing or sparking parts inside. Do not use in areas
where petrol, paint, explosive and/or flammable liquids are used or stored.
Keep unit away from heated surfaces and open flames.
Where possible, avoid the use of an extension cable as this may overheat
and cause a fire. However, if you have to use an extension cable, ensure it
is suitable for the purpose, has been tested for outdoor use and preferably
has an RCD device fitted or attached.
Always ensure the heater is plugged into a suitable socket, one that is
tested for outdoor use.
To disconnect heater, turn controls to OFF, then remove plug from socket.
Do not unplug by pulling on the power cable.
Always unplug the unit and ensure the unit is completely cold before
moving, cleaning or storing.
This heater is intended for domestic use only and should not be used
commercially for contract purposes. Any alternative use, not recommended
by the manufacturer, may result in fire, electric shock, or injury to persons.
The use of attachments on the heater is not recommended.
Warning: This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when occupied by
persons not capable of leaving a room on their own, unless constant
supervision is provided.
Check exterior walls for areas of damage before installing the heater.
Always use on a dry, suitably strong, stable, flat and level surface.
Check exterior walls for communication and electrical cables and pipelines.
Should any service lines be present in the immediate vicinity do not install
your heater, find an alternative location to install this product.
Do not position directly above or below an electrical socket.
Do not remove any of the warning stickers or signs from the product.
INSTALLATION STEPS
Take out the tripod, rotate the knob shown by the arrow counterclockwise,
open the three bottom feet, and raise the bottom pipe to the position shown
- 4 -
Publicité
