Electrical Safety - Greencut GGT200L Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

42

ELECTRICAL SAFETY

Never modify the plug in any way. Unmodified plugs and matching sockets will reduce the risk of electric shock.
If you discover any damage, send your machine to the Official Technical Service.
Do not open or attempt to repair the battery or battery charger.
Protect the battery and charger from moisture. Keep the battery away from extreme heat and cold.
Only charge the battery at an ambient temperature (surrounding air) between 0°C and 40°C.
Do not use the cable to carry, lift or unplug the charger. Keep the cable away from heat, oil, sharp edges or
moving parts. Damaged or entangled cables increase the risk of electric shock.
Do not operate the battery charger outdoors.
When not in use or before cleaning and repairing, disconnect the charger from the power source. Take special
care with the battery.
Store the battery in a dry place between 10ºC and 30ºC when not in use.
This battery is sealed and no liquid should ever leak from it. If the seal is broken and the liquid touches your skin
quickly, wash with plenty of soap and water, neutralise the liquid with a weak acid such as lemon or vinegar and
go to your medical centre urgently. If the battery liquid touches your eyes, wash them thoroughly with water for
10 minutes and call for medical assistance immediately.
The battery should be recharged when it does not produce enough energy for the work that was easily done
before. Do not continue to use the product with a dead battery.
The battery is not fully charged at the factory, before attempting to use it fully charge it first.
Never switch on the device during the charging process.
Use only batteries and chargers approved by the manufacturer.
SERVICE
Have the machine checked periodically by a qualified technician using only original spare parts. If you have any
questions, please contact the Authorised Service Centre.

Publicité

Table des Matières
loading

Table des Matières