SOMFY Amy 1 Modes io Notice page 6

Briefly press once or several times in succession the Mode button to select the

desired mode.

Number of short presses

Briefly press 1 time

Briefly press 2 times

Briefly press 3 times

Briefly press 4 times

Briefly press 5 times

Briefly press 6 times

Briefly press 7 times

Briefly press 8 times

2.2.Adding/Deleting Amy 1 Modes io

NOTICE

To program the first control point, refer to the instructions for the io drive or receiver.

The procedures for adding or deleting Amy 1 Modes io are the same.

NOTICE

It is advisable to do next steps with front panel buttons deactivated to avoid sending unwanted commands by

manipulating the module (refer to Switching on Amy 1 Modes io).

To add or delete Amy 1 Modes io, use the Somfy local io control point already paired

with the motorised product.

1] Position the motorised product at its half-way position.

2] On the individual control point already paired with the motorised product:

ð Press the PROG button until the motorised product moves up and down:

programming mode is activated.

3] On Amy 1 Modes io to be added or deleted:

ð Briefly press the PROG button: the motorised product moves up and

down and Amy 1 Modes io is added or deleted.

2.3.Switching on Amy 1 Modes io

For transportation, Amy 1 Modes io is switched off: the front panel buttons (Up, Stop/my, Down) are deactivated.

To check whether Amy 1 Modes io is switched on or off, press any front panel button and see if the feedback LED lights up.

Control mode selected

0.5 s

Low Power mode management

LPM activated

LPM deactivated

Amy 1 Modes io

2 s

0.5 s