SOMFY Amy 1 Modes io Notice page 12

3.3.Saving or modifying the favourite position (my)

NOTICE

Refer to the instructions guide for the io drive or receiver to ensure it includes this function.

1] Press the Up or Down button to send the motorised product in the desired

position.

2] Briefly press my to stop the motorised product in the desired position.

3] Press and hold my until the activation of the motorised product to save or to

modify the favourite position (my).

3.4.Checking the battery level

When the battery level is low, the feedback LED on the front of Amy 1 Modes io dims

progressively during activation of the motorised product(s). When the battery is too

weak, the control point can no longer transmit radio orders, its operation is inhibited.

Battery status can be checked on TaHoma application, if Amy 1 Modes io has been added in TaHoma, and an alert may be

sent out if this feature is activated (Follow the instructions in TaHoma application).

3.5.Use with TaHoma

A temperature sensor, not visible, is embedded into Amy 1 Modes io.

This sensor works in combination with TaHoma where it appears as an indoor temperature sensor.

When Amy 1 Modes io is added in TaHoma application and the temperature feedback to TaHoma is activated on Amy 1

Modes io, the sensor measures the temperature inside the room (around Amy 1 Modes io) and sends the measured values

to TaHoma. These temperature values can be consulted in TaHoma and can then be used for scenes to optimize home

automation.

CAUTION

Be careful in case of wind!

Automation provided by TaHoma and Amy 1 Modes io allows the automatic use of a motorised product when the

temperature of the room equals a certain threshold, without consideration of the wind.

To maximize the protection of the motorised product from the wind and limit the risk of breaking, use a wind sensor

paired with the motorised product (sold separately).

In any case, a wind sensor does not protect against sudden gusts of wind. In the event of such weather risks,

deactivate the embedded temperature sensor (see below).

3.5.1.Adding Amy 1 Modes io in TaHoma

To add or delete Amy 1 Modes io in TaHoma, you need to access and use a TaHoma switch and TaHoma

application: you must have a compatible phone or mobile device.

The application is downloadable for free from Apple Store platforms and Google Play Store on the following mobile

devices:

▪ Apple iPhone

mobile phone or mobile device with iOS operating system running iOS and later.

Amy 1 Modes io

5 s