Hints And Tips; Care And Cleaning; General Information; Troubleshooting - Zanussi ZEE6041XA Notice D'utilisation

Before first use
Put cookware containing water on each cooking
zone, set the maximum position and operate the
hob for 10 min. This is to burn off the residue in

Hints and tips

WARNING!
Refer to Safety chapters.
Cookware
The bottom of the cookware must be
as thick and flat as possible.

Care and cleaning

WARNING!
Refer to Safety chapters.

General information

• Clean the hob after each use.
• Always use cookware with clean bottom.
• Scratches or dark stains on the surface have
no effect on how the hob operates.
Stainless steel
• For stainless steel edges of the hob use a
special cleaner applicable for the stainless
steel.
• The stainless steel edge of the plate can
change the colour as a result of high
temperature.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate
the hob.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
6
the appliance. After that, operate the hob at
minimum position for 20 min. During this period,
an odour and smoke can occur. This is normal.
Make sure that the airflow is sufficient.
• Wash stainless steel parts with water, and
Cleaning the electric hotplate
1. Use the cleaning powder or the cleaning
2. Clean the hob with a moist cloth and some
3. Heat the hotplate to a low temperature and
4. To keep the hotplates in good shape, rub in
Possible cause
The fuse is blown.
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
CAUTION!
Do not use cast iron pans,
potstones, earthenware, grill or
toaster plates. The stainless steel
can become tarnished if it is too
much heated.
then dry them with a soft cloth.
pad.
detergent.
let it dry.
a sewing machine oil regularly. Polish off
the oil with absorbent paper.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Remedy
www.zanussi.com