Publicité
3
Maintenance
Recommendation for the
good use of vitroceramic
hobs
* Use pots or pans with thick,
* Pans with a smaller diameter than
the shown heating area are not
recommended.
* Do not slide pots and pans over the
glass as they may scratch it.
* Although the glass can withstand
knocks from large pots and pans
without sharp edges, try not to
knock it.
* To prevent damage to the ceramic
glass induction surface, try not
to slide the pots and pans over
the glass, and keep the bottoms
of the vessels clean and in good
condition.
Try not to spill sugar or
products containing sugar on the
glass while the surface is hot as
these could damage it.
Cleaning and maintenance
To keep the appliance in good
condition, clean it using suitable
products and implements once it has
cooled down. This will make the job
easier and avoid the build-up of dirt.
Never use harsh cleaning products or
tools that could scratch the surface, or
steam-operated equipment.
A pot or pan may become
stuck to the glass due to a product
having melted between them. Do
not try to lift the pot while the hot
glass break.
Do not step on the glass or
lean on it as it could break and
cause injury. Do not use the glass
as a surface for putting objects.
BRANDT reserves the right to make
changes to its manuals that it deems
the product's essential features.
16
Environmental
considerations
The symbol
on the product
or its packaging means that this
product cannot be treated like
ordinary household waste.This
product must be taken to a recycling
collection point for electrical and
electronic appliances. By ensuring
that this product is disposed of
correctly, you will avoid harming
the environment and public health,
which could happen if this product
is not handled properly. For more
detailed information about recycling
this product, please contact your
local authority, household waste
service or the store where you
purchased the product.
The packaging materials used are
environmentally-friendly and can
be recycled completely. Plastic
components are marked >PE<, LD<,
>EPS<, etc. Dispose packaging
materials, like household waste, in
your local container.
4
Anomalies
If something does not work
Before calling the technical service,
perform the verifications specified
below.
The appliance does not work:
Ensure that the power cable is plugged
in.
The pot sticks to the glass:
If there is molten material between
the pot and the glass, set the hot
plate to maximum power and try to
separate them.
Single Sensor Error :
If any of the sensors is active more
than 10 seconds, this error situation
occurs and error code"F1" is showed.
roots. One of them is that there may
of the sensor.
Make sure that there is no any object
on the control unit, hob glass is wiped
with a dry cloth. If error situation
continue after this solution, please
for 10 second.
Plural Sensor Error:
If more than 2 sensors are sensed at
same time, this error situation occurs
and error code"F2" is displayed.
Potential root reasons of the
problem :
sensors
• Touch control location may
exposure more heat or steam
Please be sure that there is no any
all steam and heat sources. Then,hob
glass is wiped with a dry cloth. If error
situation continue after this solution,
please take the plug out or switch off
the fuse switch for 10 seconds.
FC Error:
Fc message on the control and the
hot plates switch off: Overheating
in the electronics. Let thestove cool
for a while.
After-sales service
Any maintenance on your equipment
should be undertaken by:
- either your dealer,
- or another qualified mechanic who is
an authorized agent for the brand
appliances.
When making an appointment, state
the full reference of your equipment
(model, type and serial number).
This information appears on the
manufacturer's nameplate attached to
your equipment.
Publicité
