Cequent Performance Products 51097 Instructions D'installation

Bumper bracket
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51097F
Wrenches: Open end 3/4 wrench & 7/8"
Bumper
bracket
5
7
6
1 2
4
2
Note: Fasteners typical
both sides
1
Qty. (4) Hex bolt, 1/2-13 X 2.0 Gr5
2
Qty. (6) Conical washer
3
Qty. (2) Lock washer
4
Qty. (4) Hex nut, 1/2-13
Removal of the spare tire can make installation easier, however, removal not necessary.
1.
Raise hitch into position as shown in Figure 1. Use fasteners to attach the hitch uprights to the bumper bracket.
2. Attached remaining fasteners as shown. Item 6 must be sandwiched inside slot on bumper bracket. The hitch brackets and
the vehicle bracket will be drawn together.
3. Torque all fasteners to specifications shown below.
4. Reinstall spare tire, if it was removed prior to hitch installation. Make sure spare tire does not contact bolts.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2008, 2009 Cequent Towing Products
Installation Instructions
Bumper
6
5
7
3
4
Round spacer
washer (Item 6) fits
3 4
into slot on bumper
bracket
Hitch
Uprights
2 1
Figure 1.
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Ford F-150
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location:
Bumper bracket one piece.
Shown broken for clarity
5
Qty. (2) Spacer ¼" X 2.50 X 1.75
6
Qty. (2) Spacer round
7
Qty. (2) Flat washer 1/2"
Sheet 1 of 3 51097N
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
10,000 (4540Kg)
5000 (2270 Kg)
Bumper
bracket
2 1
6
7
5
3
4
Hitch side
bracket.
Figure 2.
Item 6 must be sandwiched
inside slot on bumper
bracket.
1-21-09
51097
Max Tongue
WT (LB)
1000 (454 Kg)
500 (227 Kg)
Rev. B