Allen + Roth LWS1176E Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
7. Thread another hex nut (EE) onto the end of the
long nipple (GG). Place the lock washer (DD) over
the end of the long nipple (GG) and then thread
the canopy chain loop (HH) onto the end of the
long nipple (GG). Using pliers, thread the hex nut
(EE) against the canopy chain loop (HH) and
hand tighten until snug.
Hardware Used
Lock Washer
DD
Hex Nut
EE
Canopy
HH
Chain Loop
8. Push the ceiling canopy (KK) upward over the
outlet box. Thread the canopy lock ring (II) onto the
canopy chain loop (HH) and tighten until snug to
secure the ceiling canopy (KK).
Hardware Used
Ceiling
KK
Canopy
Canopy
II
Lock Ring
9. Adjust the fixture chain (JJ) to the desired length,
removing links if needed. Attach one end of the
fixture chain (JJ) onto the canopy chain loop (HH)
and then attach the other end of the fixture chain
(JJ) onto the fixture loop on the top of the center
rod assembly (A).
Note: You may need to use pliers to open the chain
links. If so, put a cloth over the chain to protect the
finish.
Hardware Used
Fixture Chain
JJ
x 1
x 1
x 1
x 1
x 1
x 1
7
7
8
9
Supply Wires
A
Lowes.com/allenandroth
GG
EE
DD
HH
Outlet Box
I
HH
KK
II
KK
HH
JJ
Fixture Loop