Publicité
10
What to do if ...
Problem
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
1) Only dryers with conductance programming
2) Only dryers with removable filter
Machine settings
BUZZER permanent off
1. Turn the programme selector to any pro-
gramme.
Technical data
Height x width x depth
Drum volume
Depth with loading door open
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the DEPART/
PAUSE (START/PAUSE) but-
ton?
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at instal-
lation site differs from standard
1)
setting of machine.
2)
Filter not in place
.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
2. Press simultaneously the DELICAT
3. The buzzer is by default always off.
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Close loading door.
Press the DEPART/PAUSE
(START/PAUSE) button again.
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean fluff filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum
and drum ribs.
Re-programme standard setting
for degree of drying (see 'Ma-
chine settings' chapter)
Install filter into place
Select time programme or high-
er drying level (e.g. TRES SEC
(EXTRA DRY) instead of PRET A
RANGER (CUPBOARD DRY) ).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
(DELICATE) and TEXTILE buttons and
hold down for approx. 5 seconds.
85 x 60 x 58 cm
108 l
109 cm
Remedy
1)
.
2)
.
Publicité
