PRO-POINT 9109828 Mode D'emploi page 7

V1.0
Letter references in parenthesis (A) refer to the included Identification Key.
1. Start the motor (B).
2. Allow the motor to reach the appropriate operating temperature and
achieve a speed of 30 to 36 RPM.
3. Load the drum (A) with the concrete mix.
4. Allow for adequate time for the contents to thoroughly and properly
mix.
5. Once the mix is ready, grasp the control handle (G) firmly with one
hand and use your other hand to release the brake handle (E).
5.1 Do not release the brake handle without having a firm grip on
the control wheel.
6. Slowly turn the control handle counterclockwise to tip the drum and
release the contents.
7. Once the drum is empty, turn the control handle counter clockwise to
return the drum to its upright position.
8. Engage the brake handle to lock in place.
9. Repeat steps 3 through 8 as needed until work is complete.
10. When work is complete, turn the motor off.
11. Thoroughly clean the drum after each use and store appropriately.
WARNING! Never perform any inspection or maintenance
without first turning off the engine and disconnecting
the sparkplug wire.
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Repair or replace damaged or worn components. Only use identical
replacement parts when servicing.
3. Inspect the tool components before each use, checking for loose
screws, misalignment of moving parts and other issues that may
affect safe operation.
4. Check the oil level before each use.
Visit www.princessauto.com for more information
9 cu. ft 212cc Cement Mixer 9109828
7