Denver E-2000 RM BF Manuel De L'utilisateur page 11

•
Move the rear of the pad slightly away from the wheel rim.
•
Adjust the calliper symmetry, balancing the return springs of the right and left callipers.
•
A system consisting of a nut and a locking nut allows you to adjust the cable tension and
therefore the braking power, which will vary with time as the brake pads wear down.
Changing brake pads
- V-brake
Unscrew the pads using a 5 mm hex key.
Place the new pads on the calliper in the right direction.
Tighten the pads, using the same setting.
Rolling direction
More
tension
11