Raider Pro RDP-SRS20 Mode D'emploi page 12

12 www.raider.bg
The warranty will become void if this appliance is used in commercial or industrial enterprises and equivalent applications.
2.1. Before work
Replacing / Placing the Knife
3. Open chuck by turning it fully counterclockwise (Figure 1). This will pick up the pin and you can insert the knife.
3.1. Place the knife in the chuck (3a) and push until it stops, then tighten the chuck (3b).
3.2. Gently pull the knife to make sure it is firmly attached.
Always pull the blade to make sure it is firmly held in the chuck. Failure to do so may result in serious injury.
4. Adjust the guide driver
9
4.4. Speed adjustment
The speed are controlled by the pressure of the trigger.
All manuals and user guides at all-guides.com
4.1. Pull the driver lock lever (9) down (Figure 2).
4.2. Hold the driver (2) in the desired position.
4.3. Secure the guide (2) in place by lifting the locking lever 9) to its
original position.
WARNING! Do not work with the saw if the driver is not installedи
монтиран правилно.