Assembly Of Accessories - Weelko MAXI Mode D'emploi

ASSEMBLY OF ACCESSORIES

In case you purchased a handcontro-
ller & a foot controller as an option and
you want to use them simultaneaously,
you will need a forked cable (ref. 60037)
which has to be plugged directly in the
control box.
USING HC004.RST
See picture below for reference.
1&2: Press key 1/2 to adjust backrest.
3&4: Press key 3/4 to adjust height.
5&6: Press key 5/6 to adjust tilt function
7&8: Press key 7/8 to adjust the legrest.
9&10: In this bed model this key is ino-
perative.
11-12: Memory Set (only operative for
models with memory function included)
15: ON / OFF light: When this LED is on it
means that the handcontroller is co-
rrectly plugged in the bed.
16: Heating light indicator (only for beds
equipped with built-in heating option)
17: Reset function: Press key 17 to sett-
led the bed at 0 position.
18: Heating key: Press the key to switch
on the heating. Press it again to switch it
off. (only for beds with heating)
USING FC004.RST
EN
See picture below for reference.
1&2: Press key 1/2 to adjust backrest.
3&4: Press key 3/4 to adjust height.
5&6: Press key 5/6 to adjust the tilt.
7&8: Press key 7/8 to adjust the legrest.
ASSEMBLY OF WHEELS, (WH01.02)
For transport safety measures, the whe-
els are not installed in the bed. You will
have to screw them at arrival.
. Unscrew the 4 levelling feet placed
underneath the bed.
. Screw the 4 wheels at the levelling feet
housing.
. Remember to lock the wheels for use.
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556