LIVARNO LUX 54687 Instructions D'utilisation Et Consignes De Sécurité page 11

Never open any of the components of the electrical equipment or
insert any objects into the same components. This will pose a risk
of fatal injury from electric shock.
Touch only the insulated part of the plug when connecting to or
disconnecting from the mains supply!
To prevent hazards, if the external flexible lead on this lamp is
damaged it must be replaced by the manufacturer, its service
representative or an equally qualified professional!
Before use, verify the available mains voltage matches the voltage
required for operating the light (220–240 V ~ , 50 / 60 Hz).
Preventing fire and injury hazards
CAUTION! RISK OF BURNS DUE TO HOT SUR-
FACES! Ensure the light has been switched off and has
cooled down before touching it to avoid burns. Lamps
become very hot.
Check each bulb for damage immediately after unpacking.
Replace defective bulbs with new ones immediately. Before replac-
ing the bulb always remove the mains plug from the socket.
Allow the lamp to cool for at least 15 minutes before replacing a
defective bulb.
Do not cover the lamp with objects. Fire can result from excessive
heat development.
Position the lamp so it is protected from moisture and dirt.
Never leave the light unattended whilst in operation. Excessive heat
can result in a fire.
The LED light is not dimmable.
10 GB/IE/NI