Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
Step 1: Positioning
Move the ruler to select the cutting size, hold the handle with one hand, pull the
sliding seat to the back seat, put the tile flat on the bottom plate, put the tile close
to the front end, flush the ruler and make the right section of the tile flat with the
ruler.
Tip: Push forward the tile front end with even force.
Step 2: Line
Press down the handle so that the cutter wheel is in contact with the surface of the
tile; Push the handle forward so that the knife wheel draws a continuous, even line
across the tile surface.
Tip: If this line is not continuous, the tile cannot be cut.
Step 3: Press open the brick
The handle is lifted slightly and pulled back so the presser foot is placed smoothly
on the front end of the tile 5-10mm from the edge line. Press the handle down
appropriately, and the tile will be disconnected along the line.
- 7 -
Publicité
