VEVOR WD-A-02250-A00-0 Mode D'emploi page 4

CAUTION BEFORE USING
Due to shipment and/or handling air can be trapped in the hydraulic system, which
can interfere with the jacks lifting. To release air from the hydraulic system:
1. Open release valve by turning the jack handle counterclockwise.
2. Remove the Rubber Plug from the cylinder.
3. Rapidly pump jack handle through several full strokes.
4. Replace the Rubber Plug into the cylinder.
WARNING
1. The unlifted wheels of the vehicle should be chocked.
2. The load should be centrally located on the head cap.
3. No person should remain in a vehicle that is being lifted.
4. The vehicle manufacturer owner's manual should be consulted prior to lifting
of the vehicle.
5. The hydraulic trolley jack should be used for lifting and lowering only. And it
can not be used as a support tool.
SET UP - BEFORE USE
WARNING: Read the ENTIRE IMPORTANT SAFETY INFORMATION
section at the beginning of this manual including all text under subheadings
therein before set up or use of this product.
ATTACHING THE HANDLE
1. Attach the Upper Handle to the Lower Handle.
2. Insert the Assembled Handle into the Handle Socket. The pin on the lower end
of the Handle fits into the Handle Socket Slot.
3