Fixation Plate - Fox Spirit PGM315 Manuel D'utilisation

2. Take the cable hook out, the stand as well as the base. Take off the protective foam covering
the monitor stand. Slide the hook downwards from the back of the stand to assemble them.
Use the hand screw N ° 1 to attach the stand to the base.
3. Press the button to take the fixing plate out of the stand and use both n°2 screws to fix it.
4. Reinsert the mounting plate on the back of the monitor. The plate will click once in place. Be
careful that the stand is properly attached to the back of the monitor before removing the
protective foam and standing it up on a level table or desk safely.
Note: The foot can easily be detached from the monitor by pressing the button near the
mounting plate. Make sure that it is lying on a flat surface before removing it.
Hook
Stand

Fixation plate

Button
Hand screw N°1 x 1
Base
Screws N°2 x 2