Publicité
Les langues disponibles
Les langues disponibles
information on configuring digital sending features, see Start a scan and test digital sending
settings on page 10.
Prepare the scanner for use
1.
Attach the output tray by sliding the back of the tray into the slot under the front of the scanner.
Ensure that the output tray does not extend beyond the surface on which the scanner sits.
2.
Extend the document feeder.
3.
Extend the output tray by unfolding the flap, and then fold out the paper guides.
4.
(Optional) Install the hardware integration pocket (HIP) and accessories. With the HIP installed,
you can use accessories such as a coded card reader. For more information on the HIP, see
the electronic User Guide.
Configure the control-panel settings
Basic default settings
Language settings
After the product warms up, the messages on the control panel appear in English. You can change
the language at any time from the Administration menu. First touch the Device Behavior button, touch
the Language button, touch the preferred language, and then touch the Save button.
Date and time settings
Touch the Exit button if the date and time settings are correct. Touch the OK button to change these
settings.
Assign the IP address
The product must be assigned a valid IP (Internet Protocol) address on the network. If the network
uses dynamic host configuration protocol (DHCP), the IP address can be assigned automatically.
DHCP is the default setting in the product. Manually assign an IP address if DHCP is not being used.
Find the automatically assigned DHCP IP address
On the Home screen, touch the Device Information button. The IP address appears on the Device
Information screen.
All manuals and user guides at all-guides.com
Configure the control-panel settings
5
Publicité
