DPlus Automation Systems RAILX-C Manuel Technique D'installation page 9

AMPEROSTOP SENSIBILITY SETTING (ANTI CRUSHING)
To adjust the sensibility of the amperostop do the following :
Before programming stroke :
Ÿ Set the dip switch N ° 2-3 (look table)
Ÿ Adjust the trimmer TR1 in halfway
ŸProgram the stroke (see pag 5)
ŸAdjust trimmer TR1 so that the sensibility of the amperostop is adequate to the proper
functioning of the operator
Increase trimmer toward
strength to the operator and less sensibility
to the intervention of the amperostop
Increase trimmer toward
TR1
strength to the operator and more sensibility
to the intervention of the amperostop
SLOWING DOWN ADJUSTMENT
To adjust the slowing down speed :
Before programming stroke :
ŸOpen the door with OPEN button and adjust trimmer TR2, to have the required speed.
Increase trimmer toward + to increase the
speed
Increase trimmer toward - to decrease the
speed
TR2
Sensibility amperostop
100%
75%
50%
25%
+
to provide more
-
to provide less
Dip 2
OFF
ON
OFF
ON
TR1
Dip 3
OFF
OFF
ON
ON