Kobalt KID 324B-03 Mode D'emploi page 11

OPERATING INSTRUCTIONS
7. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (G) with the hole on the
base of the driver.
b. Insert the screw (I) and tighten the screw securely
with a Phillips screwdriver (not included).
c. To remove the belt clip, use a Phillips screwdriver to
loosen the screw holding the belt clip to the driver.
8. Installing and Removing the Bit Holder
a. Align the rib of the bit holder (H) with the hole on the
base of the impact driver.
b. Insert the screw (I) and tighten the screw securely
with a Phillips screwdriver (not included).
c. To remove the bit holder, use a Phillips screwdriver
to loosen the screw holding the belt clip to the driver.
7
8
11
G I
H I