Cleaning And Maintenance - Danby Designer DCD5505W-1 Manuel D'utilisation

Cleaning and Maintenance

Before cleaning, always disconnect the appliance
from power supply.
Exterior Cabinet
Wipe the cabinet with a soft wet cloth and mild
cleaning agent. Do not use aggressive cleaning
agents which could damage the paint surface.
Cleaning dryer
If your drier is installed in a room with poor air
circulation or if operates daily, dust deposits will
accumulate in the interior bottom of the appliance
and in the ventilation exhaust pipe.
accumulation of
malfunctions. So once a year, clean the dust in
the interior of the drier with a damp cloth and
check the exhaust ventilation for blockage.
Cleaning procedure
− Disconnect the dryer from the power supply.
− Undo the screws and remove the cover (B).
− Clean (with a vacuum cleaner) the bottom of
the drier and parts on the bottom.
− Reinsert the cover in reverse order.
USER-MAINTENANCE INSTRUCTIONS
dust can lead
Instructions for Use
Lint Filter
After each drying cycle, remove the lint filter trap
located inside the inner door and gently wipe
over the filter with a soft cloth or soft brush to
remove any accumulated lint.
cabinet as well.
The lint filter can also be cleaned under running
water; however, it must be thoroughly dried
before being replaced.
This
dryer
NOTE
The accumulation of lint on the lint filter is a
consequence
laundering and has nothing to do with drying in
the machine.
Clean the filter
of normal (wear and tear)
13