Uline H-3021 Mode D'emploi

H-3021
COURTYARD FURNITURE
MOUNTING HARDWARE
TOOLS NEEDED
Drill 1/2" (13 mm) Masonry Bit
NOTE: Best used in heavy duty, solid concrete
applications.
1. Mark the mounting location by placing the fixture
and marking through the mounting holes.
2. Drill the holes 1/2" deeper than wedge anchor
embedment using a masonry bit. (Hole size is
wedge anchor size). (See Figure 1)
Figure 1
PAGE 1 OF 3
1-800-295-5510
uline.com
Hammer
PARTS
Washer x 4 Wedge Anchor x 4
MOUNTING
Nut x 4
3. Blow out the holes.
4. Place washer then nut on the edge of wedge
anchor. This protects threads during installation.
5. Hammer wedge anchor into hole deep enough
that threads are below surface of base material.
(See Figure 2)
Figure 2
6. Tighten nut, turning approximately three or
four full turns.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0724 IH-3021