Beta 1940E10 Notice D'utilisation Et Instructions page 9

PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING AIR HAMMER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR HEARING PROTECTION WHILE OPERATING AIR HAMMER
ALWAYS WEAR EYE PROTECTION WHILE OPERATING AIR HAMMER OR PERFORMING
MAINTENANCE JOBS
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING AIR
HAMMER
ALWAYS WEAR SAFETY SHOES
Additional personal protective equipment to wear according to the values found in the environmental hygiene/risk
analysis survey if the values exceed the limits under current regulations.
WEAR ANTI-VIBRATION GLOVES WHILE OPERATING AIR HAMMER FOLLOWING A SPECIALLY
CONDUCTED SURVEY OF LEVEL OF DAILY EXPOSURE OF HAND-ARM SYSTEM TO VIBRATION
WEAR PROTECTIVE MASK AGAINST PHYSICAL AGENTS
TECHNICAL DATA
CHISEL INLET SIZE
STROKES PER MINUTE
PISTON STROKE
PISTON SIZE
AIR INLET
MAXIMUM PRESSURE
MINIMUM INTERNAL HOSE SIZE (ø)
MAXIMUM AIR CONSUMPTION
WEIGHT
LENGTH
NOISE (ISO 15744)
SOUND POWER LEVEL
SOUND PRESSURE LEVEL
PEAK SOUND PRESSURE LEVEL
UNCERTAINTY
VIBRATION (ISO 28927-10)
VIBRATION LEVEL
UNCERTAINTY
KEY TO SYMBOLS
a: air inlet 1/4" GAS
b: hammer trigger
c: chisel spindle
d: chisel spring retainer
e: chisel
f: oil lubrication
Air supply connection
For correct use of the pneumatic tool, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the
pneumatic tool with clean, condensate-free air (picture 2-a). Excessively high pressure or humidity in supply air results in shorter life
for the mechanical parts and may damage the tool.
HEXAGON 10 mm
2900
67 mm
19 mm
1/4" GAS
6.2 bars
10 mm
76.4 l/min
1.7 kg
266 mm
LwA = 104.4 dB
LpA = 93.4 dB
Lpc < 130 dB
K=3.0 dB
2
7.25 m/s
2
K=1.22 m/s