Uline H-6384 Mode D'emploi

H-6384, H-6385
π
H-6386
FIXED END STOPS
TOOL NEEDED
9/16" (14 mm) Wrench
End Stop x 1
1. Once conveyor is fully assembled, place end stop at
the end of conveyor where packages will end.
2. Line up holes on end stop with holes on end of
conveyor. (See Figure 1)
3. Place washer over hole. Insert bolt through holes
and secure with nut. Tighten nut and bolt fully.
(See Figure 2)
NOTE: Use optional spacers to allow end stop to
sit higher at conveyor end.
PAGE 1 OF 3
1-800-295-5510
uline.com
PARTS
Bolt x 2
ASSEMBLY
Pour le français, consulter la page 3.
Nut x 2
Spacer x 2
End Stop
Para Español, vea página 2.
Washer x 2
Figure 1
Figure 2
1124 IH-6384