Page 1
All manuals and user guides at all-guides.com ROTARY DJ MIXER SZ-DMR-200/ SZ-DMR-400 USER MANUAL...
Page 2
All manuals and user guides at all-guides.com WARNING! VAROITUS! Do not open cover. No user-serviceable parts inside. Refer servicing to qualified Älä avaa kantta. Ei sisällä käyttäjä-huollettavia osia. Huollot saa suorittaa vain pätevä service personnel huoltomies. Do not place the product in a location near a heat source such as a radiator, or in an Älä...
Page 3
All manuals and user guides at all-guides.com ADVARSEL! OPOZORILO! Ikke åpne dekselet. Inneholder ingen deler som kan brukes. Overlat reperasjon til Ne odpirajte pokrova. V notranjosti ni nobenih delov, ki jih uporabnik lahko sam kvalifisert servicepersonell. popravlja. Popravilo prepustite usposobljenemu osobju Ikke plasser produktet i nærheten av varmekilder som f.eks.
Page 4
All manuals and user guides at all-guides.com INTRODUCTION Thank you for choosing the SubZero DMR-200/400. This user manual will show you how to install and operate the mixing console. Users of this product are recommended to carefully read all warnings in this manual and on the unit in order to protect yourself and others from injury.
Page 5
All manuals and user guides at all-guides.com PARTS AND FUNCTIONS DMR-200 PHONES ∞ ∞ ∞ +9dB +9dB +9dB HIGH CH 1 CH 2 PH 1 / LINE 3 PH 2 / LINE 4 HIGH –10 –10 HIGH CH 2 OUTPUT CH 1 INPUT: TBC FUSE: TBC...
Page 6
All manuals and user guides at all-guides.com 17. SELECTOR SWITCH FOR THE HEADPHONES 28. PHONO SENSITIVITY MONITORING MODE Gain control for matching the input amplification of phono input 2 to line level Button pressed (SPLIT): the prefader level sources . (mono) is on one side of the headphone and the output signal (mono) is on the other side of 29.
Page 7
All manuals and user guides at all-guides.com PARTS AND FUNCTIONS DMR-400 300Hz 4000Hz PHONES ∞ ∞ ∞ +9dB +9dB +9dB HIGH CH 1 CH 2 CH 3 CH 4 PH 1 / LINE 1 PH 2 / LINE 3 PH 3 / LINE 5 PH 4 / LINE 7 HIGH –10...
Page 8
All manuals and user guides at all-guides.com 6. INPUT SOURCE SELECTOR SWICTH 19. SELECTOR SWITCH FOR THE HEADPHONES (CH 1 TO 4) MONITORING MODE Input source selector switch for channel 1-4: Button pressed = phono/line (LED lights), • Button pressed (SPLIT): the pre-fader level Button released = line (LED off) (mono) is on one side and the output signal (mono) is on the other side of the headphones.
Page 9
All manuals and user guides at all-guides.com 29. BOOTH OUTPUT (PHONO) Stereo output (RCA) for connecting a further amplifier, e.g. for the monitoring system or PA application in a secondary room. 30. RECORD OUTPUT Stereo output (RCA) for connecting a recording unit.
Page 10
All manuals and user guides at all-guides.com SPECIFICATIONS NOTE: HEADPHONES All specifications apply to both the DMR-200 and DMR-400 unless otherwise stated. Headphones ... . . 6.3 mm jack (min. 32 Ω) POWER 3.5 mm jack (min.
Page 11
All manuals and user guides at all-guides.com If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com...