Dmx Connection; Control Panel - Afx Light Tlight-Rgbw-Zoom Manuel D'utilisation

the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center. Always use the same type of
spare parts.
• Make sure the power cord is never crimped or damaged.
• Never disconnect the power cord by pulling or tugging on the cord.
• Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!.
• The product is for decorative purposes only and not suitable as a household room illumination.
• If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced
by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
• The light source is not replaceable. If it is faulty, the whole fixture must be discarded.
• The lenses, housing or ultraviolet filter must be replaced if they are visibly damaged.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope.
Never stand directly below the device when mounting, removing or servicing the fixture.

DMX CONNECTION

Connect the supplied XLR cable to the male 3-pin XLR output of your controller and the other side
to the female 3-pin XLR input of the light.You can chain multiple lights together through serial
linking
MASTER/SLAVE MODE SETTING
When the fixture is in DMX status, you can connect several machines via the signal cable, without
the use of a DMX controller. When the fixture is connected to a DMX controller, the display will show
V. When it is not connected, it will show X.
Set the first fixture into AUTO mode. Connect a DMX cable to the DMX OUT connector of fixture 1
and the DMX IN connector of fixture 2. Set the follwing fixtures into DMX mode - Channel 1. Now all
fixtures will follow the master.
If the fixture is connected to a DMX controller, the signal will be sent from the controller and you
can control the fixtures via DMX.

CONTROL PANEL

To access the main menu press the MENU button. Press the UP or DOWN
buttons until you reach function you wish to change. When you reach the
function you wish to change, press the ENTER button. When a function
is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.
EN 4
8.8.8.8.
MENU UP DOWN ENTER
© Copyright LOTRONIC 2024