Publicité
2.6
CONNECTING SUBSYSTEMS: Connecting subsystems (self-retracting lifeline, lanyard, rope grab and lifeline, cable
sleeve, etc.) must be suitable for your application (See section 1.1). See the subsystem manufacturer's instructions for
additional information. Some harness models have web loop connection points. Do not use snap hooks to connect to web
loops. Use a self-locking carabiner to connect to a web loop. Ensure the carabiner cannot cross-gate load (load against the
gate rather than along the major axis of the carabiner). Some lanyards are designed to choke onto a web loop to provide
a compatible connection. Lanyards may be sewn directly to the web loop forming a permanent connection. Do not make
multiple connections onto one web loop, unless choking two lanyards onto a properly sized web loop. To choke the lanyard
on a web loop:
Insert the lanyard web loop through the
web loop or D-Ring on the harness.
p
g
2.7
LANYARD PARKING ATTACHMENT: Figure 7 illustrates Lanyard Parking Attachments. The Lanyard Parking Attachment
is for attaching the free end of a Lanyard or harness mounted Self-Retracting Device when not connected to an Anchorage
Connection Point for purposes of fall protection. Lanyard Parking Attachments shall never be used as a Fall Protection
Attachment Element.
Park Lanyard Here.
See Instructions.
Park Lanyard Here.
See Instructions.
Insert the appropriate end of the lanyard
through the lanyard web loop.
Figure 7 – Lanyard Parking Attachments
Park Lanyard Here.
See Instructions.
7
Pull the lanyard through the connecting web
loop to secure.
Publicité
