Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
2
► 1 . Lock-off lever 2. Switch trigger
To start the tool, turn on the main power switch and grasp the han-
dle (the lock-off lever is released by the grasp) and then pull the
switch trigger. Tool speed is increased by increasing the pressure
on the switch trigger. To stop the tool, release the switch trigger.
Speed adjusting
You can select the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
1
► 1 . Indicator lamps 2. Main power button
Indicator lamps
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at our service center.
CAUTION:
This brake system is not a substi-
tute for the protector. Never use the tool without
the protector. An unguarded cutting tool may result
in serious personal injury.
1
2
Mode
High
Low
10 ENGLISH
Electronic torque control function
The tool electronically detects a sudden drop in the rotation
speed which may cause a kickback. In this situation, the tool
automatically stops to prevent further rotation of cutting tool.
To restart the tool, release the switch trigger. Clear the cause
of sudden drop in the rotation speed and then turn the tool on.
NOTE: This function is not a preventive measure for kickbacks.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
and battery cartridge is removed before carrying out any work
on the tool. Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental start-up.
WARNING:
Never start the tool unless it is completely
assembled. Operation of the tool in a partially assembled state
may result in serious personal injury from accidental start-up.
Mounting the handle
Attach the handle with supplied clamps and bolts. Make
sure that the handle is located between the spacer and
the arrow mark. Do not remove or shrink the spacer.
5
1
► 1. Clamp 2. Hex socket bolt 3. Handle 4. Arrow mark 5. Spacer
When using the following attachments, be sure to attach
the barrier to the handle using the screw on the barrier.
•
Grass trimmer attachment *
•
Edger attachment
*. Only when metal blade is attached.
► 1 . Barrier 2. Screw
2
3
4
1
1
2
Publicité
Table des Matières
