BorMann BAT6135 Manuel D'utilisation page 3

EN
Adjustment
• The desired pattern, volume of fluid output and fine spraying can easily be adjusted by regulating the pattern adjusting knob and fluid adjusting knob.
Adjusting the pattern: Turning the pattern adjusting knob to the right until tight will make the spray pattern round. Turning the knob left will make the spray
pattern elliptical.
Adjusting the volume of fluid output: Turn the fluid adjusting knob clockwise to reduce the volume of fluid output and counter‐clockwise to increase fluid
output.
MAINTENANCE
1. Pour remaining paint into another container and clean the paint ducts and air cap. Spray a small amount of thinner to clean the paint ducts. Inadequate
cleaning can cause incorrect patterns and also lead to particles entering the paint. Thoroughly clean the spray gun immediately after using two‐component
paint.
2. Clean the other parts with the provided brush soaked in thinner and with a soft cloth.
3. Clean the paint ducts fully before dismantling the spray gun.
4. Remove the paint needle before removing the paint nozzle, otherwise the tool may be damaged.
Attention:
• Never spray foods or chemicals with the spray gun.
• Never pick at the nozzle or needle with metal wires or other hard objects. This will damage them.
• Never immerse the spray gun in solvent or other fluid. This will damage the air cap, paint nozzle and paint needle.
• Always clean all the parts before reassembling the tool.
TROUBLESHOOTING
Problem
Inconsistent flow of paint / the spray gun
is making a hissing sound (''fluttering'')
Arcing pattern of sprayed paint
Pattern is not evenly spread
The center of pattern is too narrow
The pattern width is not sufficient
3
Possible cause
1. Material in container is dirty.
2. Dry or worn needle.
3. The paint nozzle is loose or worn.
1. The paint nozzle is loose or worn.
2. Material build‐up on the air cap.
1. Material build‐up on the air cap.
2. The paint nozzle is dirty or worn.
1. The paint is too thin or not sufficient.
2. The air pressure is too high.
1. The paint is too thick.
2. The air pressure is too low.
WWW.NIKOLAOUTOOLS.COM
Solution
1. Add paint into the container.
2. Lubricate or replace the needle.
3. Tighten or replace the paint nozzle.
1. Tighten or replace the paint nozzle.
2. Remove obstructions from holes,
keeping in mind not to use metal
objects for this purpose.
1. Clean or replace the air cap.
2. Clean or replace the paint nozzle.
1. Regulate the paint viscosity.
2. Reduce the air pressure.
1. Regulate the paint viscosity.
2. Increase the air pressure.