General Warnings - CAME BIANCA-C Manuel D'installation

Bianca

General warnings

• Read the instructions carefully before starting installation and proceed as specified by the manufacturer;
• After removing the packaging, check the condition of the unit;
• The packaging items (plastic bags, polystyrene foam etc.) must not be handled by children as they may be dangerous;
• Installation, programming, commissioning and maintenance of the product must only be performed by qualified technicians who have been properly
trained in compliance with current standards, including health and safety regulations;
• Operate in sufficiently lit areas that are conducive to health and use tools, utensils and equipment that are in good working order;
• The device must be installed in accordance with the IP degree indicated in the technical features;
• The electrical system must comply with current standards in the country of installation;
• Wires belonging to cables that are not used must be insulated.
• Weld the joints and the ends of the wires to prevent malfunctions caused by wire oxidation;
• When installation is completed, always check for correct operation of the unit and the system as a whole;
• Before performing any cleaning or maintenance operation, disconnect the power supply to the device;
• In the case of device failure or malfunction, disconnect it from the power supply and do not tamper with it;
• Should the unit be in need of repair, contact only a technical support centre authorised by the manufacturer and always use spare parts provided by CAME
S.p.A.
• The unit must only be used for the purpose for which it was explicitly designed.
• Failure to follow the instructions provided above may compromise the unit's safety.
• The manufacturer declines all liability for any damage as a result of improper, incorrect or unreasonable use.
Disposal
Do not litter the environment with packing material: make sure it is disposed of according to the regulations in force in the country where the product is used.
When the equipment reaches the end of its life cycle, take measures to ensure it is not discarded in the environment. The equipment must be disposed of in
compliance with the regulations in force, recycling its component parts wherever possible. Components that qualify as recyclable waste feature the relevant
symbol and the material's abbreviation.
EN
2
Installation
Remove the unit from the plastic support by sliding it after pressing the plastic button (figure 1).
1
Fasten the plastic support to the round built-in box of Ø 60 mm (figure 2) or to the rectangular box 503
(figure 3) or to the wall (figure 4), using the provided screws and observing the UP indication .
The box must be fitted at a suitable height in relation to the installer.
2
Avoid excessive tightening of the screws.
Once the connections have been made, attach the terminal to the plastic support (figure 5-6).
To release the unit from the plastic support, press the plastic hook and lift the terminal (figure 7).
1
2
5
110 31
3
6
Technical features
Absorption: 80 mA max (<1 mA stand-by)
60
Single LED absorption (ring disabled): 1 mA
Dimensions: 110x170x31 mm
Storage temperature: -25 °C +70 °C
Operating temperature: 0 °C +35 °C
IP degree: IP 20
4
1
2
7