Publicité
Les langues disponibles
Les langues disponibles
then (3
rd
) remove the metallic support together with
the refractory deflector and finally, remove the two
metallic deflectors (4
th
Fig. 7 to 9
nd
2
– Side plates
3
rd
– Refractory flame
defletor
At the end of the intervention, the parts must
be assembled in the reverse order of their
removal.
After a prolonged period without using your
appliance, and before starting it again, you should
check if there is no obstruction in the chimney.
3.8. SPARE PARTS
If you need to replace any part of your Flamebox,
we recommend that you only use original parts
(diagram on page 45).
1 – Upper flame deflector (stainless steel)
2 – Intermediate flame deflector (stainless steel)
3 – Stainless steel support profile for deflector
4 – Refractory deflector (2 or 3 parts*)
5 – Refractory side panels (2 parts)
6 – Refractory back panel (2 or 3 parts*)
7 – Fixing profile for back panel (stainless steel)
8 – Log retainer
9 – Door lock kit
10 a) & b) – Door hinge (available left and right)
P a g e
| 42
), see Fig. 7 to 9.
st
1
– Log retainer
4
th
– Metallic
deflectors
11 – Door
12 – Ceramic glass
13 – Door handle (available right and left)
14 – Ash drawer
15 – Ash grate
16 – Left side - blower / fan kit
17 – Right side - blower / fan kit
18 – Thermostat
19 – 3-way ceramic connector
20 – Resistors
21 – Rocker switch
22 – Front grill
* The number of parts depends on the model
The use of non-original parts, as well as
modifications to the intended use of your
Flamebox, voids the warranty.
4.
OPTIONAL EXTRAS
Flamebox has a set of options that you can
purchase from your Flamebox installer.
Finishing frames - available with a 30mm, 50mm
or 80mm rim, with three or four sides.
Flamebox levelling base - Compatible with all
Flamebox inserts, allows you to raise the inset
between 130 to 480mm. Each foot is independently
adjustable.
Touch controller - Allows ventilation regulation in
5 speeds. This option must be pre-installed at the
factory.
EN
Publicité
