Uline H-2960 Mode D'emploi

H-2960
3M HR933 TARTAN™
®
PISTOL GRIP DISPENSER
LOADING
1. Pull back spring-
loaded pressure bar
with thumb and clamp
tape roll to rotating
shaft. (See Figure 1)
2. With adhesive side
down, thread tape
between metal guide
and roller.
(See Figure 2)
3. Pull tape towards you.
Tear off any excess
tape. Tape is ready to
dispense.
(See Figure 3)
4. Pull tape over
smoothing roller,
allowing tape to unroll
freely off tape wheel.
(See Figure 4)
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
Figure 1
Figure 2
Figure 3
Figure 4
OPERATING
1. Start on side of box. Roll tape applicator over corner
of box, centered on top seam. (See Figure 5)
2. Pull dispenser across box top seam, applying
pressure to applicator roller to obtain a tight seal.
(See Figure 5)
Figure 5
3. End tape web 2⁄" to 3" past end of box.
(See Figure 6)
4. Bring dispenser tape wiper down against corner of
box, push down and twist slightly to cut and wipe
tape end to back side of box. (See Figure 6)
Figure 6
Para Español, vea página 2.
Pour le français, consulter la page 3.
START
HERE
0424 IH-2960