Uline H-2590 Mode D'emploi
Liens rapides
H-2590
HEAVY DUTY AUTOMATIC
TAPE DISPENSER
No power light / tape does not
feed.
Tape does not feed when unit is in
auto mode.
Blade sticks in closed position
Tape is not cut all the way through
If the troubleshooting section does not resolve your problem, contact Uline Customer Service at 1-800-295-5510.
PAGE 1 OF 3
1-800-295-5510
TROUBLESHOOTING
OPERATING ISSUE
uline.com
RECOMMENDATIONS
Unplug unit and plug in again.
Turn power switch off, wait 5 seconds, turn unit
back on.
Check that front panel is closed securely, and
safety interlock is engaged.
Verify that the fuse has not blown.
Check that Tape Length Display is 40 mm or
greater.
Check that Auto/Manual Switch is in correct
position.
Turn Interval Knob all the way
counterclockwise.
Wait 1 full second after tape is cut before
removing tape from machine.
Apply silicon oil to #242 Blade Roller.
Replace #279 blade with #279S serrated
blade.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0625 TH-2590
Manuels Connexes pour Uline H-2590
Sommaire des Matières pour Uline H-2590
- Page 1 Apply silicon oil to #242 Blade Roller. Tape is not cut all the way through Replace #279 blade with #279S serrated blade. If the troubleshooting section does not resolve your problem, contact Uline Customer Service at 1-800-295-5510. PAGE 1 OF 3 0625 TH-2590...
- Page 2 La cinta no se corta del todo Reemplace la navaja #279 por una navaja serrada #279S. Si la sección de solución de problemas no soluciona su problema, llame a la línea de Servicio a Clientes de Uline al 800-295-5510. PAGE 2 OF 3 0625 TH-2590...
- Page 3 Le ruban n'est pas coupé Remplacez la lame n° 279 par une lame entièrement. crantée n° 279S. Si la section Dépannage ne résout pas votre problème, communiquez avec le service à la clientèle de Uline au 1 800 295-5510. PAGE 3 OF 3 0625 TH-2590...