Power Cord - Pro-Point 8706160 Manuel D'utilisation

8706160
8. Grounded tools must be plugged into an outlet that is
properly installed and grounded in accordance with all
codes and ordinances. Check with a qualified electrician if
you are in doubt as to whether the outlet is properly
grounded. If the tool should electronically malfunction or
break down, grounding provides a low resistance path to
carry electricity away from the user.
8.1 Never remove the grounding prong or modify the plug
in any way, as this will render the tool unsafe.
8.2 Do not use any adapter plugs.
9. This device is only for use on 120 V (single phase) and is
equipped with a 3-prong grounded power supply cord and
plug.
10. DO NOT use this device with a 2-prong wall receptacle.
10.1 Choose an available 3-prong power outlet.
10.2 Replace 2 prong outlet with a grounded 3-prong
receptacle, installed in accordance with the CE Code
and local codes and ordinances.
WARNING! All wiring should be performed by a qualified
electrician.

POWER CORD

1. Insert the power cord plug directly to the power supply
whenever possible. Use extension cords or surge protectors
only when the tool's power cord cannot reach a power
supply from the work area.
1.1 Use in conjunction with a Ground Fault Circuit
Interrupter (GFCI). If operating a power tool in a damp
location is unavoidable, the use of a GFCI reduces the
risk of electric shock. It is recommended that the GFCI
should have a rated residual current of 30 mA or less.
6
6 IN. 1/2 HP BELT SANDER
For technical questions call 1-800-665-8685
V1.0