Possible Causes - Rowenta GS6010 Mode D'emploi

Troubleshooting
PROBLEMS
There is no steam. The appliance has not
The steam flow
is low.
Water runs
through the holes
of the steambrush.
The steamer
takes a long time
to heat.
If it is not possible to establish the cause of the problem, seek the assistance of an
pproved ROWENT Service Center www.rowentausa.com

Possible causes

been turned on.
The hose has been
obstructed.
There is no water left.
Your steamer has a build-up
of scale because it has not
been rinsed out regularly.
There is no water left.
There is condensation in
the hose.
Your steamer has a build-up
of scale because it has not
been descaled regularly.
Solutions
Check that your appliance is properly
plugged in and press the On / Off
button (on the front of the appliance).
The power light should turn on.
Check that the hose is not bent or twisted.
Turn off the appliance and refill the
water tank.
Descale the steamer at least once a
year or every 50 hours of use. If your
water is hard, increase the frequency.
Turn the appliance off and refill it.
Never use steamer in a horizontal
position. Hold the hose vertically
outstretched and wait for water to
flow back into the steamer.
Rinse out the steamer at least once
a year or every 50 hours of use. If your
water is hard, increase the frequency.
10