Switching Display For Tuner; Direct Access Tuning; Station Preset Memory; Auto Memory Entry - Kenwood KDC-PS907 Mode D'emploi

Tuner features
(See page 8)

Switching Display for Tuner

You can change the display used when listening to the radio.
Changing the Display:
Each time you press the CLK button, the display changes as
follows:
▼
Station frequency
▼
Program Service name (during RBDS station reception) /
SNPS name (only when being preset)
▼
Radio text (only during RBDS station reception)
▼
Clock

Direct Access Tuning

When you know the frequency of the station that you want to
listen to, you can input it directly for quick access.
(Function of remote)
1
Select the band by pressing the FM or AM button.
2
Press the DIRECT button.
In the display, "----" blinks for 10 seconds.
If you make no input in the 10-second period, direct access
tuning is automatically canceled.
3
Enter the frequency of the desired station while the display is
blinking.
If you want to listen to an FM station at 92.1 MHz, for
example, press 0, 9, 2, and 1.
If you want to listen to an AM station at 810 kHz, for example,
press 0, 8, 1, and 0.
NOTE
When a frequency which cannot be received is input, this
frequency is not verified and operation returns to the original
frequency input mode.
16
Function of Remote (See page 11)
Canceling Direct Access Tuning:
Press the DIRECT button again.

Station Preset Memory

Store the frequency of a station. You can then recall that
station with a single touch of a button.
1
Select the band/station that you want to have stored.
2
Press the button (#1-6) that you want to use for the station, for
at least two seconds.
The button number blinks once in the display to indicate that
the data has been stored.
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
NOTE
You can store six stations in each of the FM1, FM2, FM3, and
AM bands.

Auto Memory Entry

You can automatically store all the receivable frequencies in
the band currently being listened to, and then recall them with
the touch of a button later. This function is especially useful
when you are travelling and do not know what stations are
available. Up to six frequencies can be stored this way.
1
Select the band for which you want to store stations.
2
Press the AME button for at least two seconds to start auto
memory entry.
The numbers of the preset station buttons are shown in order.
When all the stations in a certain band are stored in the preset
memory, the auto memory entry stops. The tuner then plays
the last station received.
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.