Publicité
Les langues disponibles
Les langues disponibles
THE HIGH PRESSURE HOSE
WARNING:
Injection hazard. Fully unwrap and straighten high pressure hose prior to and during each
use and do not allow it to become kinked. The high pressure hose features an outer
covering that provides strength to the hose. If the outer covering becomes damaged, stop
using the hose and replace it immediately. A kinked or damaged hose can develop a high pressure leak
and result in a possible injection or other serious personal injury.
To prevent damage to the outer covering:
Inspect the hose before every use.
Fully unwrap and straighten hose before use.
Do not allow the high pressure hose to be kinked.
Keep hose away from hot surfaces and sharp edges.
Do not pull unit by high pressure hose.
Do not allow hose to be crushed or wrapped around objects.
WASHING WITH DETERGENT
WARNING: USE ONLY DETERGENTS DESIGNED FOR PRESSURE WASHERS.
Do not use household detergents, acids, alkalines, bleaches, solvents, flammable material, or
industrial grade solutions, which can damage the pump or cause property damage. Many detergents may
require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle. Always test in
an inconspicuous area before beginning.
Stop the engine.
Pour detergent in the soap tank. Use a funnel, if needed, to prevent accidental spilling of the
detergent outside the tank. If any detergent is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
Install the low pressure (black) nozzle into quick connect fitting of spray wand.
Start engine.
STARTING
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and the
engine instruction manual before starting pressure washer.
DANGER: Risk of fluid injection and laceration. When using the high pressure setting, DO NOT allow
the high pressure spray to come in contact with unprotected skin, eyes, or with any pets or animals.
Serious injury will occur.
1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating
of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine.
2. Check engine oil level.
3. Connect the water hose to the water source. Turn the water source on to remove all air from the hose.
When a steady stream of water is present, turn the water source off.
4.
Verify the filter screen is in water inlet of pump. NOTE: Convex side faces out.
5. Connect water source to pump inlet.
6. Connect high pressure hose to pump outlet.
7.Turn water source on.
17
Publicité
