Voltage Setting - Yeep.me Rider Manuel D'instructions

VOLTAGE SETTING

EN
After finishing the wheel diameter setting, click on the M button will show you the
voltage value. The display can match 24V/33V/36V/48V/52V battery. By clicking on
the or button, select the corresponding voltage value and then click M but-
ton to confirm, meanwhile the display will exit the voltage setting interface. (the de-
fault voltage is 36V)
SPEED LIMIT SETTING
After finishing the voltage setting, clicking the M button will enter the speed limit
setting interface and click on or button to set the limit speed. Then click M
button to confirm it, meanwhile the display will exit automatically.
WARNING : The product is designed to travel at a speed of 25 km/h. Ensure you are
following the usage restrictions of this product in terms of the road safety norms of
the country where you are using it.
WARNING : The user must comply with the requirements of national regulations
when using the bicycle on public roads, including compliance with the Highway Code.
The manufacturer declines all responsibility if the driver of the bicycle does not com-
ply with the regulations in force.
4